Properly Installation of Home Alarm System Detectors
Snoppy Huang
CPS network Forum
2016-07-01 15:10:25
Properly Installation of Home Alarm System Detectors
Wirless Magnetic door detector installation requirements:
2. the false alarm rate and the location of the installation have a great relationship, the recommended installation location should be the main member and the deputy member gap ≤2mm.
Wireless infrared detector installation:
2. infrared probe should be installed in the corner of the room to get the best detection range, without Partition, furniture, large bonsai or other partition within the detection range.
3. indoor infrared probe should be walking the line was a certain angle, infrared sensor for the radial movement of the reaction is not the most sensitive, and for tangential (ie, perpendicular to the radius direction) to move the most sensitive. In the field to select the appropriate installation position to avoid false positives infrared sensor, and seek the best detection sensitivity is extremely important part.
Wireless gas detector installation requirements:
a) First, determine the proportion of combustible gas and air, and then the alarm is fixedly mounted in a suitable location away from the gas source 1.5M within a radius of: A Gas: lighter than air, floating aloft; B Gas: lighter than air, floating aloft; C LPG: heavier than air, accumulate in low;
b) After the power is turned on, the alarm "beep" and the power light lit, functional light flashes green, about 2 minutes later extinguished, that has entered the alert, sensing when a gas leak, that issued a "tick , beep "alarm sound, while the function light is flashing red, alarm automatically alert the exclusion;
c) if the sensor fails, the alarm is issued "Di -" long song, features a long bright yellow lights, troubleshooting, automatic alert.
2. Notes:
a) Do not install outdoors;
b) Do not install to the air intake, fan, door, etc. where a large wind flow;
c) Do not install beyond the 10 ~ 50 ℃, or more humid places;
d) Do not install the alarm object and gas equipment isolated place;
e) Avoid extensive use of solid hair spray, pesticides, paint, adhesive, diluted alcohol near the alarm;
f) if the alarm failure, do not disassemble repair yourself, you can notify the supplier, or the nearest agency process.
Wireless smoke detector installation requirements:
1.the installation:
Choose a good monitoring area, the alarm is mounted on the fixed surveillance area Jin roof or ceiling can be.
2.Notes:
a) Do not install outdoors;
b) Do not install to the air intake, fan, door, etc. where a large wind flow;
c) Do not install beyond the 10 ~ 50 ℃, or more humid places;
d) alarm installation location away from the corner must be greater than 0.75 m;
e) must be dust and moisture;
3. Maintenance:
a) due to dust and other factors will cause alarm sensitivity loss, it must be tested frequently and maintenance:
b) once a week detector alarm, press the test button;
c) cleaning every six months once the alarm: Turn off the power, with a soft brush to clean the dust.
Choose a good monitoring area, the alarm is mounted on the fixed surveillance area Jin roof or ceiling can be.
2.Notes:
a) Do not install outdoors;
b) Do not install to the air intake, fan, door, etc. where a large wind flow;
c) Do not install beyond the 10 ~ 50 ℃, or more humid places;
d) alarm installation location away from the corner must be greater than 0.75 m;
e) must be dust and moisture;
3. Maintenance:
a) due to dust and other factors will cause alarm sensitivity loss, it must be tested frequently and maintenance:
b) once a week detector alarm, press the test button;
c) cleaning every six months once the alarm: Turn off the power, with a soft brush to clean the dust.